This Framed Staple Wire is 4 ply ribbon wire sandwiched and then wrapped with 36ga (0.127mm) that normal machine can't do on the market. The outer wire is wrapped to be tightest and consistent, thus the ejuice is less likely to escape from the gaps but to be vaporized. As a result the spiltback is avoided effectively.
With the Framed Staple wire, the surface area is increased, which enables better flavor and huger vapor production as well. If you are tired of the normal prebuilt wire and looking for performance coil, this is going be your best choice.
Specifications:
| Item | Ni80 Prebuilt (Unit- 1pcs) | |||
| Wire Configurations | Φ mm | Wrap | Resist | |
| Ω/coil | ||||
| Framed Staple | 2-26/4-.4*.1/36 | 3 | 5 | 0.2Ω |
| 2-28/4-.3*.1/36 | 3 | 5 | 0.3Ω | |
Warning:
Our Coils are intended for EXPERIENCED users only.
Coil resistances may vary slightly depending on the RDA/RTA and how accurately the mod reads the coils. Length of the leads go in to post holes will effect the resistance as well.All our coils have been tested several times to get the most accurate reading possible.
Knowledge on battery safety and ohms law is strongly recommended. Use at your own risk. Coilology Co,. Limited and retailers are NOT responsible for injury or damage caused to property or person due to misuse of our product.
.jpg)
